Manufacturing Process Of Storage Cage

The main components of the storage cage are divided into mesh manufacturing and chassis manufacturing.

The mesh is cut into various lengths, and the mesh is touched by a welding machine to make a semi-finished mesh. Most of the meshes are galvanized, but also sprayed. The rust-proof galvanizing is better than sprayed. The wire diameter is an important parameter of the load bearing.

The chassis is processed by the raw material plate through a bending machine. The plates are usually 1.8 and 2.5, then cut and manually welded into channel steel. The layout of the chassis is an important parameter of the load.

There are two types of bottom mesh and bottom channel steel welding. One is manual welding, which cannot guarantee that each contact point is welded; the other is the full welding technology commonly used by Shanghai enterprises, where each contact point of the channel steel and the mesh is passed. The machine welder has stronger bearing capacity.

Finally, the mesh and the chassis are assembled through the spring and the rebate.