Reasons for bending and deformation of stacking frame

1. Forklift collision

In some large rack warehouses, it is normal for forklifts to carry pallet goods. However, due to the carelessness of the forklift driver, even if the stacking rack has been reasonably equipped with anti-collision pillars and protective fences, the collision between the forklift and it is still unavoidable. If the quality is good, it may not be bent and deformed in a short time. Over time, the stacking frame will be bent and deformed.

2. The goods are not loaded and stored as required

After each design is designed, the manufacturer will calibrate the load-bearing range of the shelf. If the load exceeds its larger load when the goods are actually stored, or violates the principle of safe use of the stacking rack, it may bend and deform.

3. The production process is not detailed enough

Some manufacturers are not rigorous in the production process. If a small detail is not handled well, it may also cause it to bend and deform. For example, the size of the cutting and punching is not accurate, and the rigidity during installation may cause the stacking rack to tilt. In this case If the goods are stored underneath, the uneven force may cause it to bend and deform, or even break the laminates and columns.

4. Use defective raw materials.

In order to save costs, some unscrupulous merchants use inferior steel to process stacking racks. Although the thickness and dimensions are all the same, its load-bearing capacity is not up to the requirements. Perhaps no problems may be seen in a short period of time. Use for a period of time After that, the problem will be exposed. Generally, it will be bent and deformed. If the phenomenon is serious, it may break.